87
Troubleshooting
1
Change the mode to [
CHR
] and pull the crown out to
position
2
.
The second hand and dual time indication point to 0
position and stop.
2
Press and hold the lower right button
A
.
The hands and indication start to move to the current
reference positions stored in memory.
• Release the button as the hands start to move.
• Some hands show special movement to adjust their
position.
3
Check the reference positions of them referring to the
illustration of the previous pages.
Correct
Push the crown in to position
0
to finish the
procedure. Set the mode to [
TME
] after that.
Wrong
Proceed to step 4 in the next page and correct the
reference position.
Continued on the next page
To Next Page
Loading...
