Citizen CH-453 - Calling Up the Data Stored in Memory; How to Call Up the Data

-
Eng 18
-
Español
English Français
Pyсский
한국어
ةيبرعلا ودرا
CALLING UP THE DATA STORED IN MEMORY
HOW TO CALL UP THE DATA
• “3A” and the average value appear on
the display. (“3A” and the average value
do not appear if there are two or fewer
measurements stored in memory.)
“3A” and pulse are alternately displayed.
• 90 measurement results can be stored in the
memory.
• Except for the case where the unit is engaged
in measurement, press “MEMORY” switch to
call up the values (measurement results) stored
in memory to the display.
* To erase all the data, remove the batteries. All
the stored data is erased.
• Press the “MEMORY” switch.
CH-4531901.indb18 2019/05/3113:45