Citizen CH-456 - Time Adjustment; Setting the Clock; Adjusting Time Format

- Eng 9 -
English
Español
Français Pyɫɫɤɢɣ
Ǒ¡Ûȣ
Setting the clock enables measurements to be accurately recorded.
The monitor can record the date and time of measurement as well as the measurement results.
Be sure to set the clock after inserting the batteries. Set the date first and then the time.
1 Press and hold the Date/Time Set switch for approximately two seconds.
The “year” indicator blinks.
2 Press the
Adjust switch to adjust the “year”.
Press
Adjust switch to increase the number by one.
(The year can be adjusted in the range of 2015-2044.)
Press
Date/Time Set switch to confi rm the setting.
The “year” is set and the “month” indicator blinks.
* You can fast-forward the numbers in display by
pressing and holding
Adjust switch.
3 Press the Adjust switch to adjust the “month”.
Press Adjust switch to increase the number by one.
Press
Date/Time Set switch to confi rm the setting.
The “month” is set and the “day” indicator blinks.
4 Press the Adjust switch to adjust the “day”.
Press Adjust switch to increase the number by one.
Press
Date/Time Set switch to confi rm the setting.
The “day” is set and the “hour” indicator blinks.
5 Press the Adjust switch to adjust the “hour”.
Press
Adjust switch to increase the number by one.
Press
Date/Time Set switch to confi rm the setting.
The “hour” is set and the “minutes” indicator blinks.
6 Press the Adjust switch to adjust the “minutes”.
Press
Adjust switch to increase the number by one.
Press
Date/Time Set switch with the time signal on the
radio, etc. to confi rm the setting.
The “minutes” are set and “12” (12-hour format) blinks.
7 Press the
Adjust switch to adjust the “time format”.
The setting switches between 12-hour format (12H) and 24-
hour format (24H) each time Adjust switch is pressed.
Press Date/Time Set switch to confi rm the setting (12H or 24H).
When clock adjustment is completed, the set date and time appear briefl y and
then the display turns off.
TIME ADJUSTMENT
* When you install the batteries for the first time, the monitor will display the
clock setting screen. You do not need to perform step 1. Proceed to step 2.
If you set the clock and change its setting, start from step 1.
00CH-456All.indbEng-92015/02/1918:51:39