Citizen CH-456 - Before Requesting Repairs or Testing

- Eng 17 -
English
Español
Français Pyɫɫɤɢɣ
Ǒ¡Ûȣ
Make sure to check the following before sending your blood pressure monitor away
to be tested or repaired.
Problem Checks Response
Display stays blank when
you press the “
START/
STOP” switch.
Check whether the
batteries are dead.
Replace all the batteries
with new ones.
Check whether the
batteries are installed the
right way round (
and
oriented correctly).
Load the batteries in the
correct direction.
No measurements can
be taken.
Check whether the
measurement icon is
displayed.
Attach the cuff properly.
Check whether the cuff is
attached correctly.
Did you stay calm during
measurement?
Measure your blood
pressure again, making sure
to remain still.
Note that blood pressure measurement may not be
possible for someone with an extremely weak pulse
or cardiac arrhythmia (irregular pulse).
Your blood pressure readings are abnormally high or
low compared with those taken in hospital.
See page 16.
Other phenomena
Remove the batteries from
the unit and change them
with new ones.
* If you want to dispose this product, do not mix with general household waste.
There is a separate collection systems for used electronics products in accordance
with legislation.
BEFORE REQUESTING REPAIRS OR TESTING
DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION
Appears when the pulse
rate falls outside the
measuring range (below
39 beats/min. or above
181 beats/min.)
Attach the cuff properly again.
Take deep breaths to relax, and
measure again. (
See page
13 “TIPS FOR OBTAINING
ACCURATE MEASUREMENT”.)
The unit does not
function properly.
Contact the store where it
was purchased or your local
service center. (
See page
17 “BEFORE REQUESTING
REPAIRS OR TESTING”.)
00CH-456All.indbEng-172015/02/1918:51:45