17
E. To change batteries:
When "
" show up on the display, the battery is weak.
It will not be possible to take blood pressure measurement.
All batteries used must be the same type. Do not mix alkaline,
standard(carbon-zinc) or rechargeable (cadmium) batteries.
Do not mix old and new batteries.
Please replace both batteries together.
b. Recalling data:
(1). Press " M " button. If there is no data in the memory, only
TIME /DATE will appear on the display. If yes, the rst
reading will be the average of the latest 3 measurements.
(The average value dose not appear if there are two or fewer
measurements stored in memory.)
(2). Press " M " button again, the latest measurement will
appear with the number as well as the recording date
and time. The data called up on the display is numbered
accordingly. After reading the recalled data as rotator
99-set of the stored data, press " M " to switch to normal
time.
(3). To discontinue in the midst of reading of the data, press
"
" button.
c. Erasing data:
(1). Press the "M" button.
(2). Press hold " " and " " button to clear memories.
"CLA" show up on the display for 3 seconds.
Note: Once deleted, your data can NOT be restored.
To Next Page
Loading...
