DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION
Appears when the wrist cuff
is wrapped too loose.
Re-wrap the wrist cuff snugly.
Take another reading, making
sure you remain still.
( See page 14 “HOW TO
WRAP THE WRIST CUFF”.)
Appears when your wrist
moved during the measure-
ment.; or
Appears when the cuff is
not wrapped correctly.
Re-wrap the wrist cuff correctly.
Take another reading, making sure
you rem ain perfec tly stil l.(
See pag e 14 “HO W TO WRA P
THE WRIST CUFF
”
.)
Contact the store where it was
purchased or your local service
center. ( See page 30
“
BEFORE ASKING FOR
REPAIR/INSPECTION”.)
Re-w rap the wrist cuff pro perly.
Take deep breaths to relax, and
measure again.
( See page 13 “POINTS FOR
ACCURATE MEASUREMENT”.)
Replace two alkaline batteries
with new ones.
( See page 9
“
HOW TO
UNLOAD BATTERIES
”
.)
Cont act the st ore wher e it was
purcha sed or your local servi ce
cen ter. ( See pa ge 30
“BEFORE ASKI NG FOR
REPAIR/INSPECTION”.)
Appears when the blood
pressure could not be
measured accurately.
Appears when the pulse
rate falls outside the
measuring range (below 39
beats/min. or above 181
beats/min.)
Appears when the batteries
have run out.
The unit does not function
properly.
- Eng 27 -
English
ERROR INDICATIONS
To Next Page
Loading...
