10
Chapter 1 Setup
Chapter 1 Setup
Conrmation of Carton Contents
Removing the Packing Material
The printer is shipped with adhesive tape in place to hold the top cover
closed. Simply remove the two pieces of tape on either side of the top
cover. Then simply open the cover by lifting up and tipping it backwards.
There is another strip of adhesive tape that must be removed which holds
the mechanism closed for shipping. Remove the tape and attached paper
by carefully peeling from the plastic case.
Retain the tape should you need to transport the printer again.
CD-ROM
(User′s Manual)
Quick-start guide
Media holder bar
Media holder guide
Test label media
Power cord
Check that the following accessories are included
with the printer in the carton.
CL-S400DT
Thermal Transfer Barcode & Label Printer
Note: The empty carton and packing materials should be stored for
future shipping of the printer.
To Next Page
Loading...
