—32—
Change the settings of the paper near-end sensor to set the position at which the
near-end of the paper is detected.
1. Gently press the paper near-end sensor with your finger.
2. Keep the paper near-end sensor pressed as you move it left and right. The sensor
positions are shown below for the various diameters of the paper roll used.
*: Sensor position when shipped from the factory. However, factory settings differ depending on the
destination market.
3.8 Adjusting the Paper Near-end Sensor
(Unit: mm)
Sensor position
Paper roll outer diameter when near-end is
detected
Exterior/ interior diameter of core of
paper roll used
1
* Approximately 22.0 18/12
2 Approximately 25.2 18/12
3 Approximately 29.2 18/12
4 Approximately 34.0 18/12
The diameter of the roll of paper that is detected is an estimate. Some variations may occur
depending on the paper.
To Next Page
Loading...
