Citizen CT-S801 - Selecting a Paper Type; Paper Type Selection Procedure; Cycling Through Paper Types

—42—
Select a paper type in “Paper select” in the Function Test Mode to change the
type of paper being used.
1. Load paper.
2. While holding down button 1, turn on the power.
The function test mode starts and “Self test” appears on the LCD.
3. Press button 3 ( ) three times.
“Paper select” appears on the LCD.
4. Press button 4 ( ).
“Thermal roll” appears on the LCD.
5. Each press of button 3 ( ) cycles through the paper types on the LCD as
follows:Thermal roll  Black mark  Label  Thermal roll.
Keep pressing button 3 ( ) until the paper type you want to use is displayed.
6. Press button 4 ( ).
3.13 Selecting a Paper Type
Refer to 3.11 Loading Paper