Citizen Eco-Drive B6 Series - Chronograph Operation and Reset

19
English
Using the Chronograph
Time measurement start/stop
1
To start the chronograph, press and release the upper right button
Ⓑ
to commence time measurement.
2
To stop the chronograph, press and release the upper right button
Ⓑ
again.
3
To recommence timing from the stopped position, press and release
the upper right button
Ⓑ
again.
Reset
To reset the chronograph after stopping time measurement, press and release the
lower right button
Ⓐ
.
• Pressing and releasing the lower right button
Ⓐ
during chronograph operation
will cause timing to stop and the chronograph to reset.
• The chronograph does not function if the crown is pulled out to position
2
.
The chronograph resets if the crown is pulled out to position
2
during measurement.