51
After performing All Reset
You must set the watch again following the procedure below.
1. Correct the current reference position.
After performing All Reset, the watch is in reference position correction mode.
See from step 4 on page
44
.
2. Select a city.
See pages
18
to
21
.
3. Adjust the time/calendar.
• When adjusting by receiving the time signal manually:
See pages
30
and
31
.
• When adjusting manually:
See pages
38
to
41
.
1.
Pull the crown out to position
.
2.
Press the upper and lower right buttons
and , then release them.
The second hand moves to the “0” second position, the hour hand and date indicator
move slightly, and the watch is reset.
Troubleshooting Troubleshooting
To Next Page
Loading...
