E – 5
File name : SR100DCollege_English_text_0531_final.doc
version : 10/05/31
EQN : Use this mode to solve simultaneous linear equations
with two or three unknowns.
TABLE : Use this mode to display a defined function in a tabular
form.
VERIF : Use this mode to perform the numerical comparison
and check.
PROP : Use this mode to perform ratio expression calculations.
Give " 2: STAT " as an example:
Method : Press [ MODE ] and then key in directly the number of
the mode, [ 2 ] , to enter the desired mode
immediately.
Using " SET UP " keys
[ 2nd ] [ SET UP ] display the setup menu that enables you to specify
the input /output format, the angle mode, the numeric notation, the
statistical setting or the contrast adjustment. The setup menu consist
of two screens which you can jump between by using [
T
] and [
S
].
1: MthIO
3: Deg
5: Gra
7: Sci
▼
2: LineIO
4: Rad
6: Fix
8: Norm
▼
▲
1: ab/c
3: STAT
5: Disp
▲
2: d/c
4: SIMP
6: ◄CONT►
MthIO : Math mode displays inputs and outputs in textbook
format. (the default)
LineIO : Linear mode displays inputs and outputs in a single
line.
Deg : Deg mode sets the angle unit to degrees (the default)
Rad : Rad mode sets the angle unit to radians
Gra : Gra mode sets the angle unit to gradians.
Fix : Fix decimal setting (0 through 9)
Sci : Scientific notation (0 through 9)
Norm : Norm specifies the range (Norm1, Norm2) in which
the results are to be displayed in exponential format
or in non-exponential format (Norm1 is the default)
ab/c : ab/c displays the fraction in mixed number format
d/c : d/c displays the fraction in improper format (the
default)
STAT : STAT sets the Statistical Data Editor Screen to show
or hide the FREQ column
SIMP : SIMP sets the fraction simplification to Auto or
Manual (Auto is the default)
Disp : Disp sets the decimal point to Dot ( . ) or Comma ( , )
(Dot is the default)
To Next Page
Loading...
