137
CHECKING AND SETTING THE VALVE TIMING
Engine : RHY
SETTING THE VALVE TIMING (continued).
Tighten :
- The screw (7) of the roller (6) to 2.5 m.daN.
- The screw (9) to 2.m.daN.
- Remove the tool [1].
- Refit the tool [1].
- Tension value should be : 54 ± 3 SEEM units.
IMPERATIVE : If value is incorrect, restart the operation
- Remove tools [1].[3] and [5].
- Rotate the crankshaft 2 times (normal direction of rotation).
- Fit the tool [3].
WARNING : Should it be impossible to peg the camshaft, check that
the offset between the camshaft pinion hole and the pegging hole is
not more than 1 mm. In the case of an incorrect value, recommence
the operation.
- Remove the tool [3].
B1EP13HD
ENGINE
To Next Page
Loading...
