CLUTCH
GEARBOX
DRIVESHAFTS
235
SPECIAL FEATURES : MB3 AUTOMATIC GEARBOX
Engine : KFX
B2CP13TC
B2CP34QC
B2CP34PC
Hydraulic valve block.
Refitting.
WARNING : On refitting the strainer, ensure that the bracket (6) runs under the
washer of the screw (7).
- Refit the strainer without tightening the screws.
- Observe the following tightening sequence :
- Screws 1,2,3,4 and 5 to 0.9 m.daN.
ESSENTIAL : Respect the position of the magnets in the lower casing. Clean
the casing before placing the smooth side of the magnet against the sheet
metal.
Fitting the casing.
WARNING : The fixing brackets (8) of the lower casing have a fitting direction
(small side = lower casing side).
Tightening torque 0.6 m.daN.
SAXO
To Next Page
Loading...
