CRD vehicles (Difficult Road Conditions)
238
AXLES
SUSPENSION
STEERING
AXLE GEOMETRY
Compress the suspension to obtain the calculated values. The difference in height between the two sides should be less than 10 mm.
Measure the radius of the rear wheel: R2.
Calculate dimension H2.
Measure the radius of the front wheel : R1.
Calculate dimension H1 or H1’.
Measurements at reference height (continued). (The reference height of the vehicle is set as per the table below).
B3CP05BC B3CP05AC
XSARA PICASSO - All Types
Front axle Rear axle
FRONT AXLE
H1 = R1 – L1 ou H1’ = R1 – L1’
Essieu rear
H2 = R2 + L2
6FZ - RHZ
H1 = R1 – L1 or H1’ = R1 – L1’
Vehicles all types
L1 = 90.5mm
L1’ = 124 mm
H2 = R2 + 8.5 mm
H2 = R2 + L2
109
75.5
L1’
L1
23.5
L2
B3DP079C
To Next Page
Loading...
