94
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine : VJX (continued)
SETTING THE VALVE TIMING
- Fit the belt in the following order :
The crankshaft pinion, the injection pump pulley, the camshaft pulley, the water pump pinion.
WARNING : When positioning the belt on the injection pump and camshaft pulleys, they should
be turned in the opposite direction of rotation so as to engage the nearest tooth.
- Pre-tension (belt strip slightly tightened).
NOTE : Check that the pulley fixings are not at the end of the slots (adjust by one tooth if necessary).
- Tighten the screws (1) and (3) to 0.5 m.daN, loosen by 180°.
(Gently tighten the screws (1) and (3) by hand).
- Loosen the tensioner roller.
- Tension to 100 SEEM units.
- Tighten the tensioner roller to 2.3 m.daN.
B1EP07QC
To Next Page
Loading...
