CITROEN C-CROSSER - CHANGING A WIPER BLADE

IX
PRA
C
TI
C
AL INF
O
RMATI
O
N
1
5
1
The battery A is located under the bon-
net on the left.
To gain access to it:
) open the bonnet using the interior re-
lease lever, then the exterior safety
catch,
) secure the bonnet stay.
BATTERY
Access to the batter
y
) Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .
) Connect one end of the green or
black cable to the negative terminal
(-) of the slave battery B .
) Connect the other end of the green
or black cable to an earth point C on
the broken down vehicle, as far as
possible from the battery (for exam-
ple, right-hand engine mounting).
) Start the engine of the assisting ve-
hicle.
) Operate the starter, let the engine
run.
) Wait until the engine returns to idle
and disconnect the cables.
) Raise the front of the cover 1 to re-
lease the three clips 2 .
) Then pull the cover 1 towards you
to release the clip 3 and remove the
cover.
Check the electrolyte level regularly.
If necessary, top up the level with dis-
tilled water.
Startin
g
usin
g
another batter
y
Lookin
g
for an earth point at
the ri
g
ht-hand en
g
ine mountin
g
https://www.automotive-manuals.net/