145
9
Practical information
C1_en_Chap09_info-pratiques_ed01-2015
Removing a wheel
F Remove the label from the middle of the
spare wheel (indicating that a wheel needs
repair), and fix it inside the vehicle, where
the driver can see it.
F Remove the wheel trim using the end of the
wheelbrace.
F Slacken the wheel bolts using the
wheelbrace 1.
F Position the foot of the jack 2 on the
ground and ensure that it is directly below
one the jacking points A or B located on
the underbody, closest to the wheel to be
changed.
Ensure that the jack is stable. If the ground is slippery or loose, the jack may slip or drop -
Risk of injury!
Ensure that the jack is positioned only at one of the jacking points A or B under the vehicle,
making sure that the vehicle's contact area is centred on the head of the jack. Otherwise
there is a risk of damage to the vehicle and/or of the jack dropping - Risk of injury!
F Extend the jack 2 until its head is in contact
with the jacking point A or B used. The
contact area A or B on the vehicle used
must engage correctly with the middle of
the head of the jack.
To Next Page
Loading...
