105
Practical information
7
► Lift the exterior safety catch and raise the
bonnet.
► Unclip the stay from its housing and place it
in the support slot to hold the bonnet open.
Closing
► Hold the bonnet and pull out the stay from the
support slot.
► Clip the stay in its housing.
► Lower the bonnet and release it near the end
of its travel.
► Pull on the bonnet to check that it is locked
correctly.
Because of the presence of electrical
equipment under the bonnet, it is strongly
recommended that exposure to water (rain,
washing, etc.) be limited.
Engine compartment
The engine shown here is an example for
illustrative purposes only.
The locations of the following components may
vary:
– Air lter.
– Engine oil dipstick.
– Engine oil ller cap.
Petrol engine
Diesel engine
1. Screenwash uid reservoir
2. Engine coolant reservoir
3. Brake uid reservoir
4. Battery
5. Remote earth point (-)
6. Fusebox
7. Air lter
8. Engine oil ller cap
9. Engine oil dipstick
To Next Page
Loading...
