10
HE
K
UNNING OUT OF FUEL
DIESEL
If your vehicle is fi tted with an HDI en-
gine, the fuel system must be primed if
you run out of fuel.
This system consists of a priming pump
and a transparent pipe under the bonnet.
) Fill the fuel tank with at least fi ve litres
of Diesel.
) Open the bonnet.
) Depending on version, unclip the
cover to gain access to the priming
pump.
) Squeeze and release the priming
pump until resistance is felt (could
be from the fi rst application) and fuel
appears in the transparent pipe with
the green connector.
) Operate the starter until the engine
starts.
) Depending on version, put the cover
back in position and clip it in place.
) Close the bonnet.
If the engine does not start at the
fi rst attempt, do not try again.
Operate the priming pump again,
then the starter.
To Next Page
Loading...
