CITROEN C3 Picasso 2011 - Page 139

11
1
37
P
RA
C
TI
C
AL INF
O
RMATI
O
N
Removin
g
the cartrid
g
e
) Stow the black pipe.
) Detach the angled base from the
white pipe.
) Support the compressor vertically.
) Unscrew the cartridge from the bottom.
Beware of discharges of fl uid.
The expiry date of the fl uid is in-
dicated on the cartridge.
The sealant cartridge is designed
for single use; even if only partly
used, it must be replaced.
After use, do not discard the car-
tridge into the environment, take
it to an authorised waste dispos-
al site or a CITROËN dealer.
Do not forget to obtain a new
sealant cartridge, available from
CITROËN dealers or from a
qualifi ed workshop.
Checkin
g
t
y
re pressures
/
i
nflatin
g
accessories
You can also use the compressor, without
injecting any product, to:
- check or adjust the pressure of your
tyres,
- infl ate other accessories (balls, bicycle
tyres...).
) Turn the selector A to the
"Air" position.
) Uncoil the black pipe H fully.
) Connect the black pipe to
the valve of the wheel or accessory.
If necessary, fi t one of the adaptors
supplied with the kit fi rst.
) Connect the compressor's electri-
cal connector to the vehicle's 12 V
socket.
)
Start the vehicle and let the engine run.
) Adjust the pressure using the compres-
sor (to infl ate: switch B in position "I" ;
to defl ate: switch B in position "O" and
press button C ), according to the vehi-
cle's tyre pressure label or the acces-
sory's pressure label.
) Remove the kit then stow it.