CITROEN C3 Picasso 2011 - Page 141

11
P
RA
C
TI
C
AL INF
O
RMATI
O
N
Fitting the steel or "space-saver"
type spare wheel
If your vehicle is fi tted with alloy
wheels, it is normal to notice,
when tightening the bolts on fi t-
ting, that the washers do not
come into contact with the steel
or "space-saver" type spare
wheel. The wheel is secured by
the conical contact of each bolt.
Access to the s
p
are wheel
The spare wheel is installed in the boot
under the fl oor.
According to country, the spare wheel may
be steel or of the "space-saver" type.
For access to it, refer to the paragraph
"Access to tools" on the previous page.
Taking out the wheel
) Unscrew the yellow central bolt, and
remove it.
) Raise the spare wheel towards you
from the rear.
) Take the wheel out of the boot.
Putting the wheel back in place
) Put the wheel back in its housing.
) Refi t the yellow central bolt in the
centre of the wheel.
) Tighten fully until the central bolt
clicks to retain the wheel correctly.
) Put the polystyrene storage box
back in place.
) Put the box back in place and clip it.