11
RA
TI
AL INF
RMATI
N
Parking the vehicle
Immobilise the vehicle where it
does not block traffi c: the ground
must be level, stable and non-
slippery.
Apply the parking brake, switch
off the ignition and engage fi rst
gear to lock the wheels.
If necessary, place a chock un-
der the wheel diagonally oppo-
site the wheel to be changed.
You must ensure that the occu-
pants get out of the vehicle and
wait where they are safe.
Never go underneath a vehicle
raised using a jack; use an axle
stand.
List of operations
) Remove the bolt cover from each of
the bolts using the tool 3 (with allow
wheels only).
) Fit the security socket 4 to the
wheelbrace 1 to slacken the secu-
rity bolt (if your vehicle has them).
) Slacken the other bolts using the
wheelbrace 1 only.
) Place the jack 2 in contact with one
of the two front A or rear B locations
provided on the underbody, which-
ever is closest to the wheel to be
changed.
) Extend the jack 2 until its base plate
is in contact with the ground. Ensure
that the centreline of the jack base
plate is directly below the location A
or B used.
) Raise the vehicle until there is suf-
fi cient space between the wheel and
the ground to admit the spare (not
punctured) wheel easily.
) Remove the bolts and store them in
a clean place.
) Remove the wheel.
To Next Page
Loading...
