7
Child safety
103
C3Picasso_en_Chap07_securite-enfants_ed01-2015
"ISOFIX" mountings
- 2 rings A, located between the backrest
and the seat cushion, identified by a label,
- a ring B, located in the roof, with the TOP
TETHER logo, for fixing the upper strap.
The TOP TETHER is used to secure the
upper strap of child seats that have one. This
arrangement limits the forward tipping of the
child seat in the event of a front impact.
To secure the child seat to the TOP TETHER:
- remove and stow the head restraint before
installing a child seat on this seat (refit it
once the child seat has been removed),
- pass the child seat upper strap between
the apertures for the head restraint rods,
- fix the hook on the upper strap to the
ring B,
- tighten the upper strap.
Your vehicle is approved to the latest ISOFIX
regulations.
The seats represented below, are fitted with
regulation ISOFIX mountings.
If a child is not installed in a vehicle
correctly, the child's protection in the
event of an accident will be compromised.
There are 3 rings for each seat:
Follow strictly the advice given in the
installation instructions provided with
the child seat.
This ISOFIX mounting system provides reliable,
safe and fast fitting of the child seat in your
vehicle.
ISOFIX child seats are fitted with two latches
which are secured easily on these rings A.
Some also have an upper strap which can be
attached to ring B.
Refer to the table for the possibilities for fitting
ISOFIX child seats in your vehicle.
The rear seats must be in the fully back
position to install ISOFIX seats.
To Next Page
Loading...
