Practical information
176
C3Picasso_en_Chap11_informations-pratiques_ed01-2015
Changing foglamp / reversing
lamp bulbs
F open the boot,
F press on the tabs using 2 screwdrivers,
F disconnect the lamp unit connector,
F turn the bulb-holder by a quarter turn,
F remove the bulb and replace it.
To refit, carry out these operations in reverse
order.
Changing the third brake lamp
bulbs (4 x W 5 W bulbs)
F open the boot,
F remove the two plugs located on the boot
inner panel,
F press on the body of the lamp with
2 screwdrivers to remove it from its
housing,
F turn the corresponding bulb-holder a
quarter turn,
F pull the bulb and replace it.
To refit, carry out these operations in reverse
order.
Changing the number plate lamp
bulbs (W5W)
F insert a thin screwdriver into one of the
lens' exterior holes,
F push it outwards to unclip.
F remove the lens.
F pull the bulb and replace it.
To refit, carry out these operations in reverse
order.
To Next Page
Loading...
