127
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: RFN
Fit the timing belt (10) in place, respecting the following order:
- Guide roller (11).
- Inlet camshaft pulley (9).
- Exhaust camshaft pulley (8).
- Coolant pump.
- Tensioner roller.
NOTE: Make so that the belt (10) is as flush as possible with the exterior face of the various pinions and rollers.
Remove:
- Tool [2].
- Tool [3].
- Tool [1] from the exhaust camshaft pulley.
- Tool [5b] from the tensioner roller.
Refit:
- The lower timing cover.
- The crankshaft pulley (12).
- The screw (13).
- Tighten screw (13) to 4 ± 0,4 m.daN, then angular tighten to 53° ± 4°, tool [4].
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 127
To Next Page
Loading...
