152
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: XFW
B1EK00JD
Checking the setting of the timing (continued).
Should this not be the case, repeat the operation to refit the belt.
Remove the crankshaft peg [2].
Refitting (continued).
Refit:
- The power steering pump.
- The support (7).
- The tensioner roller assembly (1).
Tighten:
- Screw (22) to 2,5 m.daN + LOCTITE FRNETANCH.
- Screw (23) to 4,0 m.daN + LOCTITE FRNETANCH.
- Screw (24) to 2,5 m.daN + LOCTITE FRNETANCH.
- Screw (25) to 6,0 m.daN + LOCTITE FRNETANCH.
Tighten the crankshaft pulley screws to 2,5 ± 0,2 m.daN.
Refit the auxiliary drive belt (see corresponding operation).
Complete the refitting operations in the opposite order to removal.
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 152
To Next Page
Loading...
