CLUTCH
GEARBOX
TRANSMISSION
214
HYDRAULIC CLUTCH CONTROL SPECIFICATION
Bleeding the hydraulic clutch control.
Composition of the hydraulic circuit.
Brake fluid reservoir located on the master cylinder.
Hydraulic control sender located in the passenger compartment and fixed on the pedal gear.
Clutch pedal.
Hydraulic control receiver fixed on or inside the clutch housing, depending on gearbox type.
Bleed.
IMPERATIVE: Use only new, clear brake fluid, avoid entry of any foreign bodies or impurities into the hydraulic circuit.
Use only hydraulic fluid that is approved and recommended: DOT4.
IMPERATIVE: Do not use any automatic bleed apparatus (risk of the fluid emulsifying in the reservoir).
Remove:
- The pollen filter and its support (see corresponding operation in chapter on aircon).
- The air filter and its union.
- The under-engine sound-deadening.
Refill the brake fluid reservoir to the maximum of its capacity.
C5
Angl.T3-page207-255-2005. 4/02/05 15:19 Page 214
To Next Page
Loading...
