AXLES
SUSPENSION
STEERING
263
AXLE GEOMETRY: CHECKING AND ADJUSTING VEHICLE HEIGHT
Front height.
Slacken by one turn the screw (1) on the collar (2).
Retighten the screw by hand.
To decrease the height, turn the collar (2) towards the front of the vehicle.
To increase the height, turn the collar (2) towards the rear of the vehicle.
Repeat the operation to obtain the dimension calculated H1C (± 10 mm).
Tighten the screw (1) to 0,6 m.daN.
Adjust using tool [3] or tool [4].
Rear height.
Slacken by one turn the screw (3) on the collar (4).
Retighten the screw by hand.
To decrease the height, turn the collar (4) towards the front of the vehicle.
To increase the height, turn the collar (4) towards the rear of the vehicle.
Repeat the operation to obtain the dimension calculated H2C (± 10 mm).
Tighten the screw (3) to 0,6 m.daN.
Adjust using tool [3] or tool [4].
C5
B3CP06CC
B3DP08JC
Angl. T3-page256-281-2005 4/02/05 15:25 Page 263
To Next Page
Loading...
