CITROEN C5 2005 - Page 268

AXLES
SUSPENSION
STEERING
264
AXLE GEOMETRY: CHECKING AND ADJUSTING VEHICLE HEIGHT
Adjustment of heights using tool [3] or tool [4].
Connect either tool [3] or [4] to the vehicle's diagnostic socket.
Go into the menu:
- Adjustment of reference heights.
- Configuration.
NOTE: H1M = Front measured height, in mm.
All Types except CARLSSON : Calculate: 280 - (R1 - H1M).
CARLSSON : Calculate: (R1 - H1M).
Enter this value in the diagnostic tool.
NOTE: H2M = Rear measured height, in mm.
Calculate (R2 - H2M).
Enter this value in the diagnostic tool.
Wait for the vehicle height to correct itself.
Measure the front height (H1M).
Check that: H1M = H1C ± 2 mm.
Measure the rear height (H2M).
Check that: H2M = H2C ± 2 mm.
B3BP164C
C5
B3BP165C
Angl. T3-page256-281-2005 4/02/05 15:25 Page 264