B3BP16HC
312
HYDRAULICS
B3BP16GC
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUIT
Without using a diagnostic tool.
IMPERATIVE: Any LDS fluid that is collected must not be re-used.
NOTE: Collect the LDS fluid in order to keep the work area clean.
Respect the environment.
Start the engine.
Place the height control in the «LOW» position.
Stop the engine.
Vehicle with suspension Hydractive 3.
Front suspension: undo the pressure release screw (1) by one turn.
Wait for the pressure in the hydraulic circuit to drop fully.
Rear suspension: undo the pressure release screw (2) by one turn.
Wait for the pressure in the hydraulic circuit to drop fully.
C5
Angl.T3-page300-321-2005 4/02/05 15:33 Page 312
To Next Page
Loading...
