65
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: DT17BTED4
Reposition the timimg belt, strip «j» well tensioned, in the following order:
- Guide roller (19).
- Camshaft pulley (18).
- Guide roller (16).
- Camshaft pulley (23).
- Tensioner roller (20).
NOTE: If necessary, turn the pulleys (23) and (18) slightly anti-clockwise (the offset must not be
more than one tooth).
Remove the tool [4].
Using a hexagonal spanner, rotate the tensioner roller (20) anti-clockwise.
Position the index "l" facing the notch "k".
Tighten the screw (21) : 2,5 ± 0,2.
Remove the screws (15) and (17) from the pulleys (23) and (18) in order to check that the screws
(15) and (17) are not at the end of slots.
IMPERATIVE: If the screws (15) and (17) are at the end of slots, restart the operations to refit
the timing belt.
B1EP1JHD
B1EP1JJC
To Next Page
Loading...
