CITROEN C6 2005 - Page 72

66
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: DT17BTED4
Tighten the screws (15) and (17) : 2,2 ± 0,2.
Remove tools [2] and [3].
Rotate the crankshaft 8 times in the normal direction of rotation.
Fit the tool [2].
Peg the camshafts using tools [3], at "h" and "g".
NOTE: If it is not possible to refit the tools [3], slacken the screws (15) and/or (17) of the camshafts
and drive the camshafts by means of their central screws (25) and/or (26).
Peg the camshafts using tools [3], at "h" and "g".
Tighten the screws (15) and (17) : 2,2 ± 0,2.
Remove tools [2] and [3].
Rotate the crankshaft 8 times in the normal direction of rotation.
Fit the tool [2].
Fit the tools [3], at "h" and "g".
Check that the index "l" of the tensioner roller (20) is facing the notch "k".
B1EP1JHD
B1EP1JJC
Angl-C6-page022-82-2005 4/02/05 17:19 Page 66