CITROEN CX Series - Page 38

Supplement No. 1 to
Manual 818-1
(Gav)
o
(/7
OPERATION
N° MÅ.
00-855 :
ii/ting th side
jinishing
strips.
FITTING
THE
SIDE
FINISHING STRIPS
«
PALLAS
»
and
«
ADMINISTRATION »
type
1. Fitting
the
lower
body-shell
finishing
strips
Position
the
inner embellishers
: front
centre and
rear. The clearance
between
each
embellisher must
not
exceed
5
mm.
Mark and punch
the
eight fixing holes using a
pin-punch,
and f it
the
round headed
seif-tapping screws. Tighten
them.
Position the
outer embellishers,
mark and
punch each fixing
hole using a pin-punch,
and
f
it the seif-tapping
fixing
screws. Tighten
them.
1
2. Fitting the bumper
and protective pads
it
the protective pads, andsecure
them
using nuts and
contact
washers.
4
-
Op.
MÅ.
00-855 1
PDF compression, OCR, web-optimization with CVISION's PdfCompressor