CITROEN DS3 - Page 210

F Positionthefootofthejack2ontheground
andensurethatitisdirectlybelowthe
front A or rear Bjackingpointprovidedon
theunderbody,whicheverisclosesttothe
wheeltobechanged.
 Onvehiclesfittedwithsillfinishers,the
jackinglocationisindicatedbyamarking
onthefinisher.Thejackmustbeplaced
centrallyinlinewiththismarking,atthe
jackingpointlocatedbehindthefinisher
andnotontheplasticfinisheritself.
F Removetheboltsandstoretheminaclean
place.
F Removethewheel.
F Extendthejack2untilitsheadcomesinto
contactwiththejackingpointA or Bused.
The contact area A or B on the vehicle
mustbeengagedwiththecentralpartof
theheadofthejack.
F Raise the vehicle until there is sufficient
spacebetweenthewheelandtheground
sothatthespare(notpunctured)wheelcan
thenbefittedwithoutdifficulty.