CITROEN SYNERGIE - Page 255

BRAKES
248
B3FP10UC
- Use the brake pressure checking equipment 4104-T, connect diagonally and bleed:
Ø bleed screw : caliper 8x125 - Wheel cylinder 7x100.
- Set the vehicle at setting height (See the table on page 229).
SYNERGIE
BRAKES (continued)
DrumDisc
Engines : RFU - DHX
P8C
Disc
Engine : RGX
Front
Rear
Front
Rear
40 40 50
50
65
65 85
85
135
86
135
100
- If the pressures are not correct, adjust as follows :
- Refit the nut (1).
- Adjust using the nut (2) to obtain the braking pressure.
- Tighten the lock nut (3).
- Hold the threaded rod (4).
- Tighten the flanged nut (1) over the nut (2).
Checks and hydraulic adjustment of the compensator