FCC Statement
This device complies with part 18 of the FCC Rules. Operation is Subject
To the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation. Changes or modifications not explicitly
approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and candidate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15
cm surrounding the device and 20 cm above the top surface of the device
must be respected.
This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
● Increase the separation between the equipment and any other radio
device.
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
ISED Statement
‐ English: This device complies with Industry Canada license‐exempt
RSS standard(s). Operation is subject to the following two conditions: (1)
This device may not cause interference, and (2) This device must accept
any interference, including interference that may cause undesired
operation of the device. The digital apparatus complies with Canadian CAN
ICES‐3
(B)/NMB‐3(B).
‐ French: Le présentappareilestconforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter
tout brouillageradioélec triquesubi, mêmesi le brouillageest susceptible
d'encompromettre le fonctionnement.
This radio transmitter has been approved by Industry Canada to operate
with the antenna types listed with the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with
this device.
Le présent émetteur radio a été approuvé par Industrie Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un
gain admissible maximal. Les types d'antenne non inclus dans cette liste,
et dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.
To Previous Page
Loading...
