4. Network Operation Mode
[SMF-2008-A]
– 4-10 –
Table 4.14. F code list
Description
16bit
In case of rotation speed 11~24,000 x 100 [rpm]
In case of time 10~30,000 x 1,000 [sec]
In input data used for a data input operation, there are five items, “Instruction”, “Movement unit”,
“Movement speed unit”, “A code/P code” and “F code”.
Required input data items vary depending on the description of the instruction. For details, refer to
“Network Operation Mode, Instruction Combination List” on page 4-4.
To Next Page
Loading...