Claas AXION 840 CMATIC - E - TRANSMISSION; TRANSMISSION OPERATION AND MODES

5 ENGINE CONTROL ............................................................................................................. D. 10
5.1
STARTING THE ENGINE ....................................................................................................... D. 10
5.2
USING THE ACCELERATOR PEDAL AND LEVER .............................................................. D. 13
5.3
STOPPING THE ENGINE ...................................................................................................... D. 16
6 CLAAS POWER MANAGEMENT ....................................................................................... D. 17
7 FUEL .................................................................................................................................... D. 18
7.1
RECOMMENDATIONS ........................................................................................................... D. 18
7.2
BLEEDING AIR FROM THE INJECTION SYSTEM ............................................................... D. 19
E - TRANSMISSION
GEARBOX
1 CHARACTERISTICS .............................................................................................................. E. 4
2 DISPLAY ............................................................................................................................... E. 5
3 SAFETY .................................................................................................................................. E. 6
3.1
REVERSER NEUTRAL ............................................................................................................. E. 6
3.2
TRANSMISSION NEUTRAL ..................................................................................................... E. 6
3.3
ENGINE ANTI-STALL ............................................................................................................... E. 7
3.4
PROTECTION OF MECHANICAL PARTS ............................................................................... E. 8
4 STARTING THE TRACTOR ................................................................................................... E. 9
4.1
CLUTCH .................................................................................................................................... E. 9
4.2
SELECTION OF MOVEMENT DIRECTION ........................................................................... E. 10
4.3
ACTIVE STOP ........................................................................................................................ E. 11
5 BASIC OPERATION ............................................................................................................ E. 12
6 ADVANCED DRIVING .......................................................................................................... E. 14
6.1
OPERATION ........................................................................................................................... E. 14
6.2
AUTOMATIC MODE ............................................................................................................... E. 16
6.3
DRIVESTICK MODE ............................................................................................................... E. 20
6.4
MANUAL ................................................................................................................................. E. 24
6.5
SPEED RANGES .................................................................................................................... E. 29
6.6
MAXIMUM SPEEDS AND SET SPEEDS ............................................................................... E. 30
6.7
ACCELERATION .................................................................................................................... E. 34
6.8
DROOP ................................................................................................................................... E. 35
6.9
DEGRADED MODE ................................................................................................................ E. 36
AXION 840-810 CMATIC - 02/2012 - en