Claas AXION 840 CMATIC - FRONT EQUIPMENT OPERATIONS AND HITCH; FRONT LINKAGE AND POSITION CONTROL; 3-POINT HITCH SYSTEMS

3 TRANSPORT DAMPER ....................................................................................................... H. 29
4 FRONT LINKAGE CONTROLLED BY SPOOL VALVE 6 ................................................... H. 30
4.1
CONTROLS ............................................................................................................................ H. 30
4.2
SAFETY .................................................................................................................................. H. 31
4.3
PRELIMINARY OPERATIONS ............................................................................................... H. 32
4.4
OPERATION ........................................................................................................................... H. 33
4.5
EXTERNAL CONTROLS ........................................................................................................ H. 35
5 POSITION CONTROL .......................................................................................................... H. 36
5.1
DISPLAY ................................................................................................................................ H. 36
5.2
DESCRIPTION OF ADJUSTMENTS ...................................................................................... H. 37
5.3
ACTIVATION OF POSITION CONTROL ................................................................................ H. 37
5.4
UPPER LIMIT ADJUSTMENT ................................................................................................ H. 38
5.5
ADJUSTMENT OF THE BOTTOM STOP .............................................................................. H. 38
5.6
RAISING SPEED ADJUSTMENT ........................................................................................... H. 39
5.7
RATE OF DESCENT ADJUSTMENT ..................................................................................... H. 39
5.8
USING THE POSITION CONTROL ........................................................................................ H. 40
6 3-POINT HITCH .................................................................................................................... H. 42
6.1
LOWER LINKS ....................................................................................................................... H. 42
6.2
UPPER LINK ........................................................................................................................... H. 43
6.3
HITCHING AND UNHITCHING THE TOOL ........................................................................... H. 43
AXION 840-810 CMATIC - 02/2012 - en