- When starting the tractor, the power take-off may
perform several rotations. Ensure that there is nobody in
the area surrounding the tractor or the hitched tool.
- To use the power take-off, all of the power take-off
protection devices must be positioned correctly:
1 - Protection shield (Tractor side).
2 - Cardan shaft protection.
3 - Protection casing (Tool side).
4 - Device maintaining the protection (2) in position.
- Any faulty element of the protection device must be
changed immediately.
- Check that all the elements protecting the universal
drive shaft overlap
- Observe the sliding length of the cardan shaft.
- Carefully turn the tractor's wheels fully: The tyre studs
should not touch the protection devices of the universal
drive shaft.
- If it is no longer necessary to use the power take-off:
-
Stop the power take-off.
-
Remove the universal drive shaft from the tractor's
power take-off and attach it to the tool.
-
Refit the protective sleeve onto the power take-off
fitting.
-
After disengaging the power take-off, the tool may
continue turning due to momentum. Wait for the tool to
be completely stopped to approach the tool.
- Check that the speed and rotation direction of the
tractor’s power take-off match the speed and rotation
direction accepted by the tool to be driven.
461msn00m
6.1.7.7 Severe applications
6515
Always call a CLAAS approved dealer when planning severe use (e.g. twinning, transport with public works trailor,
use of combined tools, etc.) to check the availability of reinforced wheels, and if required request their installation..
Subsoilers,subsoilers and ditchers and trench ploughs always work at great depth.
Their use requires high tractive forces and often causes considerable overloading which, in the long term, can
damage your tractor.
To use your tractor normally:
- Carefully adjust the tractor's ballast.
- Never exceed the load capacity of the tractor.
AXION 840-810 CMATIC - 02/2012 - en
A. 17
To Next Page
Loading...
