Need help?Do you have a question about the Claas ROLLANT 250 roto cut and is the answer not in the manual?
General| Type | Round Baler |
|---|---|
| Model | ROLLANT 250 roto cut |
| Bale Diameter | 1.25 m |
| Bale Width | 1.2 m |
| Working Speed | Up to 12 km/h |
Critical safety rules to prevent personal injury during operation and maintenance.
Technical data for CLAAS ROLLANT 240/250/254/255 RC, including dimensions and capacities.
Essential checks and observations before starting the baler operation.
Instructions for attaching the baler to the tractor, including drive shaft connection.
Detailed steps for connecting universal drive shafts with taper lock and shear bolt couplings.
Procedures for adjusting drawbar height, hitch eye, and connecting to various hitches.
Connecting hydraulic hoses for tailgate, pick-up, and knives using control valves.
Adjusting pick-up height for transport, working, and different crop conditions.
Adjusting hydraulic baling pressure and spring tension for bale density.
Procedures for inserting net, setting net wraps, and twine/net wrapping system configuration.
Operating the baler with standard controls, including twine and net wrapping modes.
Detailed steps for automatic twine and net wrapping processes.
Procedures for clearing blockages using the cam-type cut-out clutch or manual rotor reverse.
Using the hydraulic rotor reverse device for clearing blockages.
Interpreting fault symbols and error messages on the Control Terminal.
Configuring settings like number of wraps, delay time, and automatic tailgate.
Setting up the baler via the Setup menu, including wrapping selection and parameters.
Interpreting fault symbols and error messages displayed on the CLAAS Communicator.
Performing automatic twine and net wrapping, including manual overrides.
Troubleshooting common issues with twine wrapping not starting or feeding correctly.
Diagnosing and resolving issues with net wrapping initiation, netting feed, and wraps.
Procedures for unhitching, using wheel chocks, and adjusting parking support.
Important safety notes and general guidelines for performing maintenance tasks.
Procedures for maintaining the hydraulic system, including depressurizing and hose checks.
Guidelines on lubrication, oil types, grease, and specific points to lubricate.
To Next Page
