21
CLAGE
Setup menu
2
8
4
7
5
3
6
9
+
1
Display flashes
Press
≥ 3 sec
The arrow key resets the display to zero when mode “s” is chosen.
The arrow key deactivates the display of the clock.
Load decrease
Setting of load shedding parameters
Setting options:
“0“ Operation without load shedding relay, factory setting
“1“ operation with standard load shedding relay
“2“ operation with sensitive load shedding relay
Lock level
Limitation of appliance’s operation complexity.
Setting options:
“0“ no restriction (factory setting)
“1“ factory reset via key (countdown) not possible, parameters can be seen but not be modi-
fied in setup menu
“2“ same as “1”, additionally the setup menu cannot be opened
“3“ same as “2”, additionally nominal value memory (handwash, shower, bathtub, kitchen)
not changeable
“4“ same as “3”, additionally nominal value not changeable
Temperature limit
The maximum settable temperature can be reduced to any value within the tempera-
ture limit.
The Lock level must be activated via placing the jumper to enable the limitation. Refer
to the installation manual to this.
Flow limit
Setting of flow rate limitation.
Setting options:
“--“ no flow rate limitation
“At“ automatic adjustment, i.e. flow rate is limited in a way so that the selected outlet
temperature is reached
“Eco“ flow rate limitation to max. 8.0 l/min
e.g. “9.0“ limitation to a selected value
Note:
“Eco” is displayed when operating mode “Eco” is selected and the set temperature is
below 43 °C.
3. How to use
Menu item order of “Setup menu“
LANGUAGE
TONE
BACKGROUND LIGHT
CHARGES PER KWH CT
CLOCK
LOAD DECREASE
LOCK LEVEL
TEMPERATURE LIMIT
FLOW LIMIT
To Next Page
Loading...
Need help?
General
