Clarion NZ503 - Page 29

Audio Setup
Menu
This menu
includes:
Balance, Fader,
Select
EO,
Sub
Woofer Ctrl,
Sub Woofer Phase, High Pass Filter,
low
Pass Filter,
Amp
Cancel and Magna Bass
EX.
Balance:
Choose
the
desired volume for left and right
speaker.
Fader:
Choose the desired volume for front and rear
speaker.
Select
EQ:
Choose
the
desired mode: Bass Boost,
Impact,
Excite, Custom and
OFF.
Sub Woofer
Ctrl:
Choose the desired sub woofer gain
from
0
to
14.
Sub Woofer Phase:
Choose the sub woofer phase
normal
or
reverse.
High Pass Filter:
Choose the high pass filter
through/55Hz/85Hz/120Hz.
Low
Pass
Filter:
Choose the low pass filter
through/62Hz/95Hz/135Hz.
Amp
Cancel:
Choose the amplifier audio output on
or
off.
Magna
Bass EX:
Choose the loudness on
or
off.
Navigation Setup
Menu
This menu includes:
GPS Time, Navi
Interrupt,
and
Voice Guidance
GPS
Time:
Set
the system time
to
be synchronized
with GPS
local time
or
not.
Navi Interrupt:
There are three choose: On/Popup/
Off. "On":
The navigation screen will cover
to
AV
screen when reaching some key point.
"Popup":
When
28
NZ503
small turn info window will
pop
up
in the
top
of
the
AV
screen
to
indicate
the
key
point
.
"Off"
:
Turn
off
this
function.
Voice Guidance:
Enable
or
disable the navigation
voice guidance.
Voice Guidance Mix:
There are
two
choose:
On/Off.
"On":
The navigation voice guidance will play
at
the
same time and the voice
of
the current source.
"
Off
":
Only
the navigation voice guidance. (Voice Guidance
On)
Others Setup
Menu
Settcngs.
~~
General
Set
Password
Locked
V1deo
Parental
Control
Kid
Sdfe
Audio Audio
LJ
nguage
fnglish
N•v•qat1on
Subtrtte
Language
English
'
ll'
\~·1
S'1sl~1n
Language
US
t:>9IISI'
Set
password:
Set
the password
for
DVD parental
control.
Parental control:
Set
the rating
of
the age.
It
contains
Kid Safe/G/PG/PG-13/PG-R/R/NC-17/Adult.
Audio Language:
Set
the Language for DVD Audio.
Subtitle
Language:
Set
the Language for DVD subtitle.
System Language:
Set
the Language for system
screen.
Blinking
LED:
Select the blinking LED
On/Off.
Screen Calibrate:
The function
of
it is to select the
TS
Calibrate
YES
or
NO.
Factory
Default: The function is
to
select
to
load
factory default
or
not.