Clark C35 D - Page 144

,QGH[
How to Perform Planned
Maintenance
........................... 7-14
How to Tow a Disabled Truck
... 6-2
How to Use Battery Jumper
Cables
...................................... 6-4
How to Use this Manual
............. viii
Hydraulic Control Levers
........ 3-30
Hydraulic Fluid and Filter
Change
................................... 7-24
Hydraulic Sump Tank
............. 7-24
,
Indicator Lights ....................... 7-18
Instrument Pod
......................... 3-4
Introduction
..................................vi
Introduction
............................... 7-2
.
Keep Away from Forks
Decal
...................................... 3-35
Key/Start Switch
..................... 3-27
/
Lateral Tip-over ...................... 1-13
Lift Chain Inspection and
Measurement
.......................... 7-28
Lift Chain Lubrication
.............. 7-28
Lift Chain Maintenance
........... 7-27
Lift Chains
............................... 7-26
Lift Control Function
............... 3-30
Lift Mechanisms and
Controls
.................................. 7-18
Load Handling
........................ 4-11
Load Handling Components
... 7-14
Long and Wide Loads
/ Rear Swing
............................. 2-3
Longitudinal Tip-over
.............. 1-13
Loose Loads
............................. 2-2
Low Overhead Clearance
Fast Turns and High Loads
...... 2-4
Lubrication
.............................. 7-25
Lift Chain wear and
Replacement Criteriai
............. 7-28
0
Major Component Locations
..... 7-8
1
Neutral Start Switch
................7-17
No Riders
..................................1-5
Normal Operation
......................7-9
2
Operating Safely
.......................4-7
Operator Compartment
.............3-3
Operator Daily Inspection
...........vii
Operator Protection
...................1-7
Operator Safety Warning
Decal
.......................................3-34
Operator/Tip-Over
...................3-34
Overhead Guard
.....................7-14
Operator Controls
...................3-27
3
Pallets and Skids ......................2-8
Parking
....................................1-15
Parking Brake
.........................7-18
Parking Brake
.........................3-28
Parking Brake Pedal
...............3-27
Password operation
................3-21
Pedestrians
...............................1-6
Picking Up and Moving
Loads
......................................4-13
Pinch Points
..............................1-9
Planned Maintenance
.................vii
Planned Maintenance
Intervals
....................................7-9
PM Report Form
.....................7-12
Pod Symbols and Functions
.....3-5
Positioning Forks and Upright
...4-5
Powershift Transaxle
................8-3
5
Refueling Gasoline and
Diesel Trucks
............................5-5
Refueling LPG Tanks
................5-6
Right-Angle Stacking
................2-6
Right-Angle Stacking
................2-6
Routine Servicing and
Maintenance
............................... vi