Clas Ohlson CD-7920 - Page 3

3
English
• Always disconnect theappliance from thewall socket:
- if amalfunction occurs
- before cleaning
- if theappliance is not to be used for along time
- after each use
• Theelectrical socket to which theappliance is connected should be protected by anRCD
with atripping current of 30 mA.
• Place theappliance on afirm, flat and level surface. Never operate theappliance on asoft,
pliable surface such acushion or quilt.
• Fill the tank with water before plugging the appliance into an electrical socket.
Never place your hands into the water when the appliance is switched on.
• Make sure that thewater level in thetank does not exceed themaximum mark.
Items not suitable for ultrasonic cleaning
Soft jewellery such as pearls
or jewellery made of:
• Emerald
• Ivory
• Coral
• Agate
• Sea shells
These items are too soft and may scratch during cleaning.
Welded or plated metal items.
Glued items.
Ultrasonic cleaning may enlarge any gaps inside thejoints.
This can cause thejoints to fail and theitems to come apart.
Watches with lower water-
resistance ratings than
10 ATM/100 m.
• Remove thewatch strap from thewatch and wash thestrap in
thebasket if thewatch has alower rating than 10 ATM/100 m.
• In order to be able to use theincluded watch stand which
holds thewatch above thewater, thewatch casing must be
water resistant to at least 10 ATM/100 m.
• Theultrasonic waves might cause water to penetrate
thecasing of watches with lower water resistance despite
them being held above thesurface of thewater.
• Never immerse awatch in thewater tank of theappliance,
regardless of its water resistance rating.
• Make sure that theany buttons on thewatch are pushed in
and that all theseals are in good condition before placing
thewatch in theholder.
10ATM/100m <10ATM/100m