Clas Ohlson EMW100R - System Programming and Operation; Programming the Transmitter and Receiver; Operation

4
English
Programming thetransmitter and receiver
1. Connectthereceiver to awall socket.
2. Holdin [ON/OFF Learning Code] on thereceiver for 5 seconds until theLED (1)
starts flashing.
3. Holdin [OFF] on thetransmitter for 2 seconds (until theLED on thereceiver goes
off) for thechannel you wish to use on thereceiver. If[OFF] is released too early,
theprogramming will not work.
Note: Do not press thebuttons on thetransmitter too hard; light pressure (just enough
to light up theLED on thetransmitter) is all that is needed. Ifyou press too hard
theprogramming will not work.
Operation
• Press [ON] or [OFF] for theselected channel (1–4) on thetransmitter to turn on
oroff theelectrical devices connected to thereceiver on that channel.
• Press [ALL OFF] or [ALL ON] to activate or deactivate all thereceivers at
thesametime.
Specifications
Battery A23, 3LR50, V23GA (12 V)
Frequency 433.92 MHz
Range Up to 70 metres (unobstructed)
Receiver EMW100R (36-1859)
Description
• Wireless transmitter and receiver, easy to set up and use.
• Range up to 70 metres if unobstructed.
• A red LED on thereceiver comes on when it has been turned on by thetransmitter.
TheLED goes off when thereceiver is turned off.
• The programmed channel is permanently saved in thememory.