Clas Ohlson EMW100R - Receiver Connection and Specifications; Connection; Specifications

6
English
Connection
• Set thepower switch of theelectrical device that is to be connected to thereceiver
to OFF.
• Connect theelectrical device to thereceiver before it is connected to apower point.
• Turn thedevices on by setting their power switches to ON, I etc.
Specifications
Voltage 230 VAC, 50 Hz, 16 A
Max power 3680 W (resistive load),
150 W (inductive load, e.g. fluorescent lamp)
Protection class IP20
Frequency 433.92 MHz
Range Up to 70 metres (unobstructed)
Note:
• Other wireless equipment using thesame frequency can reduce
thetransmission range.
• The range of all wireless equipment depends on thetype of obstacles located
between thetransmitter and thereceiver (e.g. aconcrete wall will interfere with
thesignal more than aplasterboard wall).
If you experience problems, try thefollowing:
• Turn off any existing wireless equipment to see if that could be causing
theproblem.
• Move thewireless equipment and/or shorten thedistance and reduce
thenumber of obstacles (walls, furniture, etc) between thetransmitter
andreceiver.