Fig. 1
OPERATION
WARNING
Operating Aerator
1. Start engine.
2. Make sure the rear tires are in the up position (tines
not touching ground). Slowly pull back on the con-
trol handle(s). Figure 1
3. Move aerator to the work area.
4. Release control handle and push down on lowering
handle putting tines in the turf.
5. Pull back slowly on the control handle to begin
aerating. For maximum penetration into turf, apply
downward pressure on handle. This model has
three tine hubs that drive independently to allow for
easier turning.
6. When nished aerating, release control handle, wait
for tines to stop moving, pull up on lowering handle
to remove tines from turf and move wheels into
transport position.
Stopping Engine
1. Release control handles.
2. Turn off ignition switch.
Lowering Handle
Control Handle
11
AERATOR
To Next Page
Loading...