13
OPERATION
Recommended Height Adjustments
Seeding / Multipurpose Height
The seeding/multipurpose blades are used for cutting
grooves for over-seeding and can also be used for
verticutting grasses. To set the height properly place unit
on the lawn surface and adjust the wheel height up (see
Fig. 4 ). Adjusting the wheel height up lowers the blades.
Seeding:
The proper height setting for over-seeding is
approximately 1/4” into the ground. Adjust the wheel
height up approximately one notch. If
set deeper, grass seed being applied may not germinate.
For best results, over-seed in two passes of 1/2
application rate at right angles or in a criss-cross pattern.
Water heavily immediately after seeding then lightly for
10-14 days keeping soil moist.
Fig. 4
To Next Page
Loading...
